200 TQW wipers

[Kneale Brownson]

Pop out the caps at the wiper arm bases, take off the nuts (13mm?), pull 
the arms off the knurling below the threaded parts of the rods, realign to 
your liking and snug down the nuts again.  Activate the washers to see if 
the arms work ok (additional tightening of the nuts may be required), and 
replace the caps when you're satisfied.


At 09:07 AM 10/06/2000 -0600, Lawson, Dave wrote:

>I am wondering if anyone knows how to reset the stop point
>for the wipers on my 1990 200 TQ wagon. In the rain and snow
>over the past few days, the wiper stop point has changed from
>its normal park position, to gradually moving across the windshield.
>At this point the wiper is parked at about a 60 degree angle,
>conveniently right in the drivers line of vision. I have played with
>the interrmitent and on positions and turned the car off to try and
>get it to reset, but no luck.
>
>Any BTDT on getting the wipers back to the normal park position
>would be greatly appreciated.
>-
>Dave Lawson
>1990 200 TQW
>1983 urq
>