check engine light MIA - 89 100Q

[Pete Gotseff]

Hi all,
	While investigating a non-functioning check engine light 
(bridging FP relay per Bentley) in my '89 100Q (built 4/88) I 
discovered that it is, in fact, missing.   Pulling the dash revealed 
that there was no wiring to the light at the far right hand side of the 
dash cluster.
Current findings:
1) Could not find evidence of cut or abandoned wiring anywhere. 
2) Could not find correct wire in wiring diagram (Bentley) to trace 
CE light from Ign control unit to emply dash location.  
3) Multifunction dash display does have a check engine light 
symbol when run through its "check" mode -  does that count?

Can someone tell me what wire to trace from control units (Ign or 
FI) so that I may find out where my CE light may have gone.  Or 
perhaps where to hook up an LED for pulling the codes.  Not sure 
what to do since Bentley assumes CE light exists for early 100Q.

Plz help.



	
-------------------------
Peter Gotseff
pag at hydrosphere.com
-------------------------