Recomend a Fuel Pressure Gauge?

[Ameer Antar]

JC Whitney has a kit for $55 which works ok. The fittings had to be 
tightened A LOT to keep them from leaking. And you're supposed to get new 
o-rings after you've used it. Ask them if they can get the o-rings. I 
didn't know they were needed, but I'm sure any good parts store can get me 
new rings. The pressure gauge is quite helpful...that's how I diagnosed a 
bad warm-up regulator. good luck. Don't forget they usually offer 10% off 
on their catalogs too.

At 01:32 PM 9/12/00 -0700, you wrote:

>Heya,
>
>   Can someone recommend a relatively affordable fuel pressure gauge with 
> the dual inputs so I can check control pressure and system pressure on an 
> MC or similar CIS motor?   I found a Snap On one but at $250 I 
> laughed.  ANd the only ones I've found at Shucks and some other stores 
> are single input that just give system pressure.
>
>   Also, can you suggest a place to get it?
>
>   Thanks
>
>
>Todd Phenneger
>83' ur-q (awaiting a 20vt)
>84' 4ktq fun but I'm sick of CIS.
>
>
>
>Do You Yahoo!?
><http://mail.yahoo.com/>Yahoo! Mail - Free email you can access from 
>anywhere!