Stroker

Russell T. Neyhart rneyhart at sover.net
Tue Sep 19 07:42:41 EDT 2000


    Forgive me if this has been asked before, but there don't seem to be
many Eurovans around to begin with, much less ones available to donate their
engine.  Where could one be found?
Russ

> Eurovans up to 93 have a compression ratio of 8.5 to one.. The later
models use 10.0 to one. The block I got for my 2.5 turbo had pistons with a
dish similar to the early turbos. Later pistons have a dish that resembles
the high compression 2.3's .. The eurovan block lacks the oil cooling jets
under the cylinder bores, is missing a distick tube mount and a rear heater
outlet flange. All can be machined (as I did in mine)..
>
> Scott
>
> In a message dated Wed, 6 Sep 2000 11:34:34 PM Eastern Daylight Time,
JShadzi at aol.com writes:
>
> << In a message dated 9/6/00 8:24:37 PM Pacific Daylight Time,
> jjpetek at hotmail.com writes:
>
> << I have been recently thinking about the eurovan stroker
project/problem.
>  Can someone tell me what the stroke of the eurovan 5 cylinder is (I have
>  looked online for hours now to no avail)?  Am I correct in assuming that
>  there are no clearance problems and also in assuming that the journal
>  dimensions are equal?  Lastly, will the crank work in the 7A and the 3B?
My
>  concern with this swap is the catastrophic piston speeds that will result
>  from the hugely oversquare nature of the bore/stroke ratio.  Thanks for
your
>  help listers.
>
>  jason petek
>  83 UR Q
>  _________ >>
>
>     The stroke of the crank is 95.5mm.  It will fit in any 5 cylinder
block,
> but using stock rods, custom pistons will be needed to make up for the
> difference in the stroke.  The easiest way to do this is to simply swap
the
> whole block over from a Eurovan, but in a turbo application the 10:1
> compression will be too high.  The pistons could be machined to lower
> compression.  Eurospec offers a complete kit including pistons, rods,
crank
> and all components necessary to complete the swap.  They also offer
complete
> bottom ends assembled with the required compression.  If you are intersted
in
> these products let me know off list.  HTH,
> Javad
> _______________________________________________
> Quattro mailing list    Quattro at audifans.com
> To remove yourself, change to digest mode, or temporarily stop delivery
> please visit the web interface at
> http://www.audifans.com/mailman/listinfo/quattro
>  >>
>
>
> _______________________________________________
> Quattro mailing list Quattro at audifans.com
> To remove yourself, change to digest mode, or temporarily stop delivery
> please visit the web interface at
> http://www.audifans.com/mailman/listinfo/quattro




More information about the quattro mailing list