Pilot Bearing

JShadzi at aol.com JShadzi at aol.com
Wed Aug 15 20:21:54 EDT 2001


Hmm, odd, do you have the 01A tranny with Torsen?  If so, the input shaft is short and thick, it would not even reach to the crank if you wanted to use the other type.  Mine is an '88, early too, with the later style, I believed that the change was with the 01A tranny, I would believe it if you still had an 016?
Javad

In a message dated Wed, 15 Aug 2001  6:11:16 PM Eastern Daylight Time, Huw Powell <audi at mediaone.net> writes:

> 
> > The NG 2.3 uses a small sealed bearing (like a small wheel bearing) held in
> > the flywheel with 2 circlips, very easy to remove unlike earlier cars with
> > the bearing imbedded in the crank.
> 
> Weird, my 90Q (NG) was just like the 4k.  Must have changed over at some
> point?
> 
> -- 
> Huw Powell
> 
> http://www.humanspeakers.com/audi/
> 
> http://www.humanthoughts.org/





More information about the quattro mailing list