MC-2 oversized pistons or not?/Denver Machine shop

[Jim Green]

--- Avi Meron <avim at pacbell.net> wrote:
> If the ridge is as small as you are describing it I
> would defiantly not mess
> with it!!!!!!!!!!!!!!!!!!!!!
> When you hone the cyl.s (you are aware that it is a
> must, right!) you more
> than likely will smooth it out.
> Stay out from oversize pistons, they are hard to
> get, spendy and not worth
> the effort in your case!
>
> Take care, and good luck,
> Avi
> www.ultranator.com

Man, I hope that's the case.  I guess I'll have to
bring it in and see if they can hone it, and keep it
in spec for normal pistons.  Can anyone recommend a
machine shop in Denver area?  I'm going through the
yellow pages, but I would rather go by someone's word.
Thanks,

=====
Jim Green
'89 90tq EFI
http://www.geocities.com/jeg1976/car_home.html

__________________________________________________
Do You Yahoo!?
Check out Yahoo! Shopping and Yahoo! Auctions for all of
your unique holiday gifts! Buy at http://shopping.yahoo.com
or bid at http://auctions.yahoo.com