MC-2 oversized pistons or not?/Denver Machine shop

ed armstrong edshred2000 at yahoo.com
Fri Dec 21 13:53:03 EST 2001


Jim,

The spec on cylinder/piston wear limit is 0.003". You
might want to start looking at oversize pistons as a
back up plan.

 -ed


--- Jim Green <jeg1976 at yahoo.com> wrote:
> --- Avi Meron <avim at pacbell.net> wrote:
> > If the ridge is as small as you are describing it
> I
> > would defiantly not mess
> > with it!!!!!!!!!!!!!!!!!!!!!
> > When you hone the cyl.s (you are aware that it is
> a
> > must, right!) you more
> > than likely will smooth it out.
> > Stay out from oversize pistons, they are hard to
> > get, spendy and not worth
> > the effort in your case!
> >
> > Take care, and good luck,
> > Avi
> > www.ultranator.com
>
> Man, I hope that's the case.  I guess I'll have to
> bring it in and see if they can hone it, and keep it
> in spec for normal pistons.  Can anyone recommend a
> machine shop in Denver area?  I'm going through the
> yellow pages, but I would rather go by someone's
> word.
> Thanks,
>
> =====
> Jim Green
> '89 90tq EFI
> http://www.geocities.com/jeg1976/car_home.html
>
> __________________________________________________
> Do You Yahoo!?
> Check out Yahoo! Shopping and Yahoo! Auctions for
> all of
> your unique holiday gifts! Buy at
> http://shopping.yahoo.com
> or bid at http://auctions.yahoo.com


__________________________________________________
Do You Yahoo!?
Send your FREE holiday greetings online!
http://greetings.yahoo.com



More information about the quattro mailing list