[200q20v] shifter boot

[C1J1Miller at aol.com]

In a message dated 7/16/01 11:36:58 AM Eastern Daylight Time, malth at umich.edu 
writes:

> All,
>  
>  Since I got the 200q20v back, I've noticed that somehow the shifter boot
>  and square mounting part got pulled up.  I can realign it and get it to
>  sort of line up and snap in, but only one side of the boot (the right
>  side) seems to say attached and the left side just lays down and then
>  gets pulled up later after a few shifts.  What's the proper way to make
>  the boot stay on?
>  
>  Chris
>  '91 200q20v

There are two bolts at the rear outside edges with nylon, that retain two 
ears on the boot housing.  They're likely loose.  Push down the boot; pull 
the side trim away; tighten bolts.
Chris