in urgent need of advice - ignition switch

[JShadzi at aol.com]

Yes, it is held on by two very small set screws, you need to pull the whole 
steering columg to get to them, trying to do it with the column in the dash 
is likely impossible and very frustrating.

HTH,
Javad

In a message dated 7/25/2001 7:45:35 PM Pacific Daylight Time, 
jlenorovitz at yahoo.com writes:

<< 
 I'm trying to change the ignition switch (just the electrical part) in my 
'95 90Q
 and I can't quite figure out how it's supposed to come out.  I've taken the 
wiring
 harness off of it and it doesn't appear that the switch is really attached 
to the
 key-tumbler part by any obvious fasteners.  It's pretty hard to see though.  
It sure
 doesn't want to pull straight out and I've tried to pry it about as much as 
I'm
 comfortable with, but with no results.  Any advice or BTDT's on taking it 
out? 
 Judging from the looks of the new replacement part it should just come right 
out,
 but I'll wait for some advice before I push it too far.  Thanks,
 
 Joel
  >>