4ktq w/MC1 timing question

[Orin Eman]

> With the flywheel mark at -0-, cam pulley mark lined up with valve cover,
> and rotor pointing at the mark on the distributor housing, I assume ignition
> timing is set to 0degrees.  Is this where I leave it,

That's where you leave it.  Ignition timing comes off a pin in the flywheel,
62 deg BTDC and you cannot affect it.  Other than routing the spark to
the right plug, the distributor setup merely enables
the ECU to differentiate between compression and exhaust stroke.

Orin.