boost problem

Oliver M. Llenado omllenado at hotmail.com
Mon Jun 18 22:18:38 EDT 2001


here is the story,

1.1 bar, replaced the mm hose 
1.2 bar, then discovered a leak in the upper & lower wastegate hose, replaced it then 
1.0 bar,

there is a writeup in sjm's site on trouble shooting the wire connection, usually just removing and re-installing the thing solves the problem.

your on the right track, I just disconnected the muti func temp switch pin & clean it with an electronic parts cleaner and re-installed it, now am getting 1.4 bar,
sometimes the temp gauge fails to work, I just re-insert the pin connection.

the temp sensor is located near the radiator hose, it is covered with a rubber cap, 4 wire pin. mine is installed upside down.

does your temp gauge work?, 

with regards to the wastegate diap, you can test the diap with a vacuum, sjm also have some write-ups although I did not go that far.

I will be installing an autometer boost gate which I got from eBay and a pair of Infinity tweeters I love working on this car.

gud luck on your repairs.


Oliver M. Llenado
805 Dahlia Street Apt 22
Denver Colorado 80220 U.S.
Home (303) 322-6613
Mobile (720) 849-8762
www8.ewebcity.com/omllenado

  ----- Original Message ----- 
  From: The Balakrishnans 
  To: omllenado ; quattro at audifans.com 
  Sent: Monday, June 18, 2001 6:18 PM
  Subject: Re: boost problem


  Oliver:  Did you ever get this problem resolved.  I am having a similar problem with my 5kcsq ... I have a new MM hose, a new breather hose, replaced all injector seals and injectors and after all of this the best I am able to get in boost is 1 bar except when I floor the accelerator and the engine takes a long time to get to 1.3 bar.  The car is very sluggish, and all the work seems to have made no difference at all in terms of performance.  All I am looking for is to get to stock performance.  

  I also have a 90 200 TQW which does not handle as well as the 87 5kcsq sedan but has a significantly more responsive engine.

  Any suggestions will be appreciated.
    ----- Original Message ----- 
    From: omllenado 
    To: quattro at audifans.com 
    Sent: Wednesday, May 16, 2001 12:00 PM
    Subject: boost problem



    after discovering that the lower wastegate hose is limp and leaking, I replaced it .   
    was experiencing 1.2 bar boost with the leaking hose, when I replaced the hose just 1.0 bar.

    already replaced the michelin man hose, throttle switch, upper wastegate solenoid hose, correct plugs, new wires, 
    the temp gauge doesnt get high though I was thinking the multi temp sensor needs replacing, I just replace all the possible parts that needs replacing.
    any suggestions?, next step is the temp sensor, where can i find this? then the wastegate diap'


    Oliver M. Llenado

    Denver Colorado 80220
    Homepage http://www8.ewebcity.com/omllenado


-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.audifans.com/pipermail/quattro/attachments/20010618/57953577/attachment.htm


More information about the quattro mailing list