Machining Piston to lower compression?

Stephen Bigelow sbigelow at sprint.ca
Thu Mar 1 08:59:39 EST 2001


CR= (V1+V2+V3+V4)/(V2+V3+V4)

Where V1 is calculated swept volume, V2 is deck height volume, V3 is head gasket volume, and V4 is combustion chamber volume.

Cutting pistons increases V2.

Steve Bigelow, who found that FIAT X1/9 combustion chambers are remarkably well balanced from the factory.


       


  ----- Original Message ----- 
  From: JShadzi at aol.com 
  To: quattro at audifans.com 
  Sent: Wednesday, February 28, 2001 10:42 PM
  Subject: Machining Piston to lower compression?


  Anyone familiar with doing this?  Know how to calculate it or someone who 
  can?  I have a high compression motor I want to turbo charge, and want to 
  lower the compression this way..it is an 82.5mm bore, so no low compression 
  pistons are available. 
  Javad 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.audifans.com/pipermail/quattro/attachments/20010301/b3f424ab/attachment.htm


More information about the quattro mailing list