i dunno if anyone can check this out in the family album

[JShadzi at aol.com]

<< ve been following the thread regarding 10v/20v parts interchangeability,
 firstly i  didnt know the 20v head could be mounted on the 10v block, is
 this right and what needs to be done (obviously custom exhaust).>>

Well, the head will bolt to the block, just use the right head gasket 
according to bore, the rest will have to be figured out regaring manifolds, 
final compression, bracketry, and engine control...

 <>

Any 10v bottom end will result in very low compression, because of that you 
really should just use the 20v bottom end for 10.3:1 compression, or an NG/NF 
bottom end for 8ish:1 compression.
 
 <<And lastly can anyon point me to were i ca find all this stuff out??   (not
 the russian catalog site please) >>

Good luck, I don't think its been documented, much less very much 
experimented with, I have been thinking a lot about it though with some 
others on the list.
Javad
80tq