Turn signal problem
Huw Powell
audi at mediaone.net
Wed May 30 21:56:47 EDT 2001
> I am repairing electrical problems on an 1991 100q. Had to replace both
> switch assembles on the steering column. After replacing I cannot get the
> turn signals to work properly. When the ignition switch is in the off
> position:
> - emergencies flash
> - Air conditioner solenoid turns on and off with flasher
> - When wipers are in any position they also turn on and off with the flasher
> When the ignition switch is in the on position:
> - The correct turn signal operates continuously( does not flash)
> - emergencies are also on contin.
> - head lamps work fine thank God
>
> Any suggestions
Sounds like a wiring problem...
Time to dig out the bentley and one by one make sure wires are the right
color to the right place, not metled or cut, and have continuity.
Ditto, measure switches to make sure they do what they are supposed to.
This may sound like a lot of work but it is probably the only way to do
it.
Make some photocopies of the relevant diagrams - that way you can mark
them up as you work.
--
Huw Powell
http://www.humanspeakers.com/audi/
http://www.humanthoughts.org/
More information about the quattro
mailing list