K-26 disassembling question

[Konstantine Bogach]

Ameer,

could you send me a diagram and spec of wear tolerances.
Thank you very much.

Konstantin Bogach.


>
> From: Ameer Antar <ameer at snet.net>
> Subject: Re: K-26 disassembling question & hoses...
>
> I see your in the middle of the rebuild....There should only be one nut
> holding the shaft to the turbo. Make sure both the compressor side and
> exhaust side housing have been removed. Once you loosen the nut, you should
> be able to take it apart. If it's stuck....very, very gently use a rubber
> mallet to hit the shaft out of the bearing housing from the compressor
> side. Be very careful. Also as you take the turbo apart write down how
> every little part goes in...sometimes it can be hard to remember exactly
> which side goes which direction, etc. Also make sure you have a decent
> diagram to compare to and specs for measurements like shaft diameter,
> piston ring groove, bearing diam's., etc. Let me know if you're missing a
> diagram and this info; I have a copy of one, but it's a big file.
>
> About hoses, pegasus auto racing has a very good selection of race-type
> parts, like silicone hoses, even coolant hose, and other goodies. You can
> order their catalog from here: http://www.pegasusautoracing.com/
>
> good luck.
>
> -ameer
>