10v -> 20v -> 20vt

[Richard Hoffman]

If an MC would be in the 6:1 range, what about say..an NF or NG block where
the  compression is higher to start with?

Richard
1990 CQ 193K
----- Original Message -----
From: <JShadzi at aol.com>
To: <mswanson at mswanson.com>; <millerds at muohio.edu>; <quattro at audifans.com>
Sent: Wednesday, November 21, 2001 7:13 AM
Subject: Re: 10v -> 20v -> 20vt


> I have a 20v head bolted to a block right now, I will use clay on the
pistons
> to get a feel for the clearances, I will let you know if a week or two.
If
> the NG pistons need much relieving, it may not be worth it, maybe a little
> nick here and there, ideally they wouldn't need any.
>
> Yes, the MC with a 20v head will be in the 6 range.
>
> Javad
>
>
> In a message dated 11/20/2001 11:40:03 PM Pacific Standard Time,
> marcswanson at mediaone.net writes:
>
> << Maybe the 6.5:1 figure I was getting was when used with the MC block.
> Have
>  you bolted an NG block to a 7A head to check for clearances before?
Would
> be
>  nice to know if it fits once and for all (eg piston clearances, etc)!  >>
>