10v -> 20v -> 20vt

[JShadzi at aol.com]

I have a 20v head bolted to a block right now, I will use clay on the pistons
to get a feel for the clearances, I will let you know if a week or two.  If
the NG pistons need much relieving, it may not be worth it, maybe a little
nick here and there, ideally they wouldn't need any.

Yes, the MC with a 20v head will be in the 6 range.

Javad


In a message dated 11/20/2001 11:40:03 PM Pacific Standard Time,
marcswanson at mediaone.net writes:

<< Maybe the 6.5:1 figure I was getting was when used with the MC block.
Have
 you bolted an NG block to a 7A head to check for clearances before?  Would
be
 nice to know if it fits once and for all (eg piston clearances, etc)!  >>