Nice CQ(S2 Look) and 20v in Burlington, VT

[Per Lindgren]

Not when the main light switch is off. The projector beam is low only, it has a
single filament H1 bulb. When the main light switch is on, the low beams are
supposed to be on all the time, independent of the flash or high position. On my
car, which had H4 dual filament bulbs originally, the low goes out when I flip
to highs, but low stays on when I flash.

PerL
92 Cabrio 2.3E

TM wrote:

> When you flash, shouldn't both the driving lights and the high beams
> flash, for a total of 4 filaments?
>
> I'm not certain w/ the RS2 lights as I don't know if the projector beam
> is low only or not.
>
> Taka
>
> -----Original Message-----
> From: quattro-admin at audifans.com [mailto:quattro-admin at audifans.com]On
> Behalf Of Per Lindgren
> Sent: Wednesday, September 26, 2001 11:19 AM
> To: Alexander van Gerbig; Quattro
> Subject: Re: Nice CQ(S2 Look) and 20v in Burlington, VT
>
> Alexander van Gerbig wrote:
>
> >     Today I spotted a CQ with the full frontal S2 look, even euro plates,
> > sweet looking CQ.  I flashed and got a flash back, but noticed the poor
> > guy's RS2 lights are wired improperly, high beams were only one bulb per
> > side, it should be both for highs.
>
> You mean, that when he flashed, only the highs flashed, not the lows? This
> is
> quite normal, and the way they are supposed to be. The light flasher is only
> wired to the highs.
>
> PerL
> 92 Cabrio 2.3E (Also with RS2 lights)