cutting metal fuel lines - How?

[Richard Beels]

You'll need to pop the line out from the little rubber blocks.  Use a
screwdriver to pry open the metal clips.  Then you can use either a small
plumbing-type pipe cutter or a hacksaw.  Be prepared to get wet with gas if
the lines are pressurized.  You will need to debur the ends also.  Check
the archives for my post about doing fuel lines....

At 19:29 04/13/2002,  Dave Hord was inspired to say:
>
>Hey all...
>
>I have fuel leak. I bought the correct neoprene fuel line for high-pressure
>systems, so I can splice in a section for now.
>
>The splice will be in for 3 weeks, but only 4 days of driving (off to the
>roll-
>cage shop).
>
>What's the best way to cut the metal fuel line to remove the leaking portion?
>
>It's so tight to the car, I'm low on ideas.
>
>-Dave


Cheers!