Another 5KSQ Idle Switch Question

[Huw Powell]

> Thanks to Phil and Huw for answers to my previous idle switch question.
> You've convinced me to replace it this Saturday.  How do I disconnect the
> wires?  One goes to a connector mounted nearby which I can probably figure
> out.  But the other one goes underneath something nearby.  What's that?  A
> ground?  Is the connection there just a small bolt?

not entirely familiar with your switch setup, but what I would *expect*
is a three pin connector with wires enclosed in little sheaths going to
each switch, WOT usually on top of the TB and the idle switch under it.

Removing and replacing the idle switch underneath is often easier if you
remove the TB from the IM, just four allen head bolts, which can be a
bit tough to get started but easy after that to remove.  The type 44
might give you a little more elbow room under there than the little
cars, though.

--
Huw Powell

http://www.humanspeakers.com/audi/

http://www.humanthoughts.org/