Replace clutch

[Phil Payne]

> 2.  Should I replace the slave cylinder while I am at
> it ?? or is it best to leave alone ??

Well, when you have everything off, try and figure out how to do the
job in situ without breaking at least one arm in two places.

IMO it's well worth doing at the same time.

> 3. I also recall reading that when you do this job,
> you should replace the heater water outlet pipe
> O-ring, at the back of the block.  Does anyone have
> any comments/suggestion on this ?  Thanks in advance.

I've never thought about it, but it seems a good idea.  The cost is
minimal, but I've never known one of these leak unless disturbed.  You
might want to think about replacing the heater control valve while
you're there, and check the fuel lines where they pass through the
rubber grommets in the clips.

Exhaust hangers?

--
  Phil Payne
  http://www.isham-research.com/quattro
  +44 7785 302 803
  +49 173 6242039