climate control error15 and 09 - '90 90q20v

[agaidos at got.net]

 I'll give that a try. I had a shop quote me $400 bucks. No thanks
Thanks
Anton

Quoting Fred Munro <munrof at sympatico.ca>:

> I had the same problem on my '91 200q, Anton, with the same error codes.
> I
> cleaned up the temp flap motor connector and treated it with Stabilant
> 22 -
> problem solved.
> 
> Fred Munro
> '94 S4
> 
> ----- Original Message -----
> From: "Gaidos,A." <agaidos at got.net>
> To: "Quattro" <quattro at audifans.com>; "Audi20V List"
> <audi20v at rennlist.org>
> Sent: Wednesday, January 16, 2002 7:26 PM
> Subject: climate control error15 and 09 - '90 90q20v
> 
> 
> > All,
> > Still trying to figure this one out. The climate control for my 1990
> 90q20v
> > is giving me both 09 and 15 on channel one of the diagnostic program.
> I'm
> > getting no heat at all.
> >  My understanding is 15 is the flap control motor for heat and 09 is
> for
> an
> > open at the temp control sensor. I'm guessing the temp sensor is at
> the
> back
> > of the head below the battery try with 2 wires coming out and is not
> the 4
> > wire multi function sender to the temp guage. Is this correct?
> >  Going to channel 06 to check that sensor I get something like this:
> -|55
> > which doesn't show up in the chart inmy Bently.
> >  Anyone care to offer their experiences?
> > Thanks
> > Anton
> >
> > -----Original Message-----
> > From: Gaidos,A. [mailto:agaidos at got.net]
> > Sent: Sunday, January 13, 2002 11:51 AM
> > To: Audi20V List
> > Subject: climate control error15 - '90 90q20v
> >
> >
> >  All,
> > Last night coming home (in what is very cold weather for Santa Cruz)
> my
> > heater stopped working. Today I did a diagnostic on it and got the
> > following:
> > Error code 15. It then flashed to 00 but then back to 15. When I
> switched
> to
> > channel 7 I got 2, 6 and 7 for flap settings. Basically it's set for
> cold
> > air from footwell and defroster in recirculation mode (if I'm reading
> it
> > correctly).
> >  Anyone know a straight forward way to address this?
> > Thanks
> > Anton
> >
>