MAC11B problem?
Brian Devlin
bdevlin at stanford.edu
Sun Jan 20 19:50:19 EST 2002
While trying to figure out my coolant sensor problem, I noticed
something strange on my ECU harness: the wires at positions 6 and 34
have been cut. The wiring diagram shows that these would go to
ground, but I can't see the other ends. Is this an undocumented
factory change or some bad re-engineering (and maybe the cause of my
problem)?
In regards to the sensor problem: swapped the two senders, both
sender tests OK, wire has 0 ohms, and swapped the ECU with a
presumed good unit. Smae poor starting, same code.
-Brian
-86 5kcstq
More information about the quattro
mailing list