200q20v inlet O-ring size?

[Kneale Brownson]

--
At 04:30 PM 07/25/2002 -0400, JShadzi at aol.com wrote:

>Ya, but 69.5 was a rough estimate based off a recent measurement for using
>rubber hose, which has a lot of tolerance to sizing.  I'd say the true
>size of the ID is 70mm, the cross over tube has a very nice machined
>portion that interacts with the 0-ring.  Making them could be an option,
>how would you re-attach the cord to itself to make a "o"-ring?

There's an adhesive you can use with some O-ring materials for forming
"O".  Works best if the ring pretty much sits in a housing and gets
compressed by the adjacent part of the housing.  I've used this stuff on
tractor hydraulic cylinders.

Don't know if there's an adhesive for the kind of material Brett's
considering using, though.
--