removing rear ball joints...how?

[VwOne8T at aol.com]

   Just loosen up and remove the pinch bolt. Then either use a pickle fork or 
if you have an Air hammer, use a flat bit and lightly hit the control arm 
downward. Be careful doing it that way though if you use to much force you 
could damage the C/A. to get them back in just hit upward on the ball joint 
after the shaft part is in the hole. I use a hammer and no wood, some people 
will say you will damage it that way but I have never had a problem.

good luck
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.audifans.com/pipermail/quattro/attachments/20020316/57a01b0b/attachment.htm