rear output seal leaking on trans

[james accordino]

Sorry, I missed the seal q.  It's a Kuko (sp. ?) 9mm
thick.  They had them in 10, 8 and 7mm.  I went with
the 10mm.  Just mike it or take it to the bearing
place.  It's a stock item at each house I called.


I just did one in an 89 200q thanks to a spent rear
bearing.  The whole T*rsen comes right out by removing
the carrier end plate.  To disassemble you'll need
large snap-ring pliers and a press.  Very simple
procedure on this car.

HTH
Jim Accordino

--- "Richard J. Andrews" <tech at flashmail.com> wrote:
> any way to change one of these?
> i just put the transmission in and didn't see a way
> to do this seal.
> anyone have a part number for it?
> this is the seal that is where the driveshaft
> connects,
> already changed both of the left and right output
> seals.
>
> TIA!
> rich
> '86 4kq
>


__________________________________________________
Do You Yahoo!?
Yahoo! Movies - coverage of the 74th Academy Awards®
http://movies.yahoo.com/