5000 tach question...

[bahbah blacksheep]

thats exactly what i was lookin for..

thanx rich!

jim
>
>distributor hall sensor is what feeds it if i recall correctly.
>most likely a weak solder connection or one of the pins that feed the tach
>on the pc board in the cluster.
>
>HTH!
>
>-rich
>At 06:03 PM 5/7/02, you wrote:
>>well.. ONE tach IN a 5000.
>>
>>anyone know what lives at the other end of the tachometer? mine's bee
>>screwy
>>lately and id like to know where to look before i dig into it. the problem
>>is intermittent, the tach usually registers 1-2000 rpm low, and then will
>>"jump" up to the right rpm, then fall back down to the wrong rpm. its
>>really
>>annoying.
>>
>>it strikes me as probably an electrical connection [i seem to remember
>>reading the tach was fed off a flywheel sensor??], but before i resolder
>>all
>>the points on the gauge cluster, id like to inspect whatever sends info to
>>the gauge.
>>
>>tia,
>>jim
>>
>>same old me, new email address...
>>
>>_________________________________________________________________
>>Chat with friends online, try MSN Messenger: http://messenger.msn.com
>>
>
>




_________________________________________________________________
Chat with friends online, try MSN Messenger: http://messenger.msn.com