200TQ oil cooler fittings

[Jim Green]

--- Kent McLean <kentmclean at mindspring.com> wrote:
> Gentlepeople,
>
> After the oil cooler hose on my 200 TQ failed for
> the second time,
> I'm trying to remove the old hoses. While I have the
> connectors
> soaking in PB Blaster, does anyone know the size of
> the hex
> fasteners that connect the hose to the oil cooler
> and oil filter base?
>
> My largest open end wrench (spanner) is 19mm, which
> is way too
> small. An adjustable wrench opens to 1 inch, which
> is almost there.
> Is the hex fitting 26mm or 27mm?

Pipe wrench.

> And while I'm on the subject, has anyone replaced
> the standard
> connectors with AN pieces? I'm looking for the
> metric-to-AN adapter
> size, and the AN fittings and hose sizes.

18x1.5mm to -10 AN adapters see how I had it at

http://www.geocities.com/jeg1976/oil_cooler.html

I've cleaned it up sice then, but the lines are the
same.

HTH,

=====
Jim Green
'89 90tq EFI
http://www.geocities.com/jeg1976/car_home.html

__________________________________________________
Do You Yahoo!?
Yahoo! Health - your guide to health and wellness
http://health.yahoo.com