FW: RE: Installing rear child seat tethers in a 200 wagon

[Michael, Dave]

> Hi Dan
>
> I faced exactly the same problem on my 200 qa.
>
> To solve it, I made a "U" shaped bracket  from 3/16" x 1.5" steel bar
> (approximate dimensions). the ends of the U are very short, and have a
> hole  thru which the wheel well cover (or 3rd seat) bolts. the bottom of
> the U spans the width of the car, between bolts. i can send a picture of
> it installed if you like.
>
> In the bottom of the U , i drilled holes to which I mounted the audi
> parts. - they end up mounting  in the same place as the were intended.
>
>                                |-- hole for Audi belt kit
>                               v
>     _____________ ________________
>    |                                                            |
>    |                                                            | < screw
> hole for tire cover mount  screw (large, designed to hold a 3rd seat)
>
>
>                                |     back
>                                V