CV Boot 80q

[JShadzi at aol.com]

--
[ Picked text/plain from multipart/alternative ]
Since the stock bolts are stretch, you should also use that bolt supplied in
the kit to replace the stock bolt too, not just to pop out the joint.  That
wasn't too clear in your email below.  Definitely don't pull the whole shaft
just to change the outer joint, absolutely no need too, the trick Jim
describes works really well.

Javad

In a message dated 11/2/2002 8:06:33 PM Pacific Standard Time,
jeg1976 at yahoo.com writes:

> I bought a kit, and in that kit was a big Allen head
> bolt, I too tried hammering the joint off, but with no
> luck.  So I took the bolt and screwed it into the
> joint until it popped it off the axle.  It was really
> easy once I figured out what that bolt was for!  Also,
> make sure and replace the retaining clip before you
> put the joint back.