Removal of clutch slave cyl

[Mihnea Cotet]

At 12:20 26/11/2002 -0500, Louis-Alain Richard wrote:


>Anyone know the actual size of the rollpin?  There are punches designed
>specifically to drive out roll pins.  They have a little round
>protrusion on the end surrounded by a shoulder to keep them centered in
>the pin.  Of course, you need one the right size to fit into the opening
>in the tranny case.

Thanks for the tip, I'll try this when I need to swap the clutch slave in
my car :-)

Talk to you later in french dude :-)


Mihnea