Turbo conversion question - crank sensors
Mihnea Cotet
mik at backus.info.fundp.ac.be
Sat Oct 26 00:29:42 EDT 2002
At 14:15 25/10/2002 -0700, Lines Peter wrote:
>How do you install the crank position sensors when you put a MC engine
>into a car with NA engine? As far as I could see, the transmission on
>the NA cars doesn't have the holes for the two sensors..
>
>--
>E. Spangen
>'86 Audi 100 2.2 CS quattro
>
>
>The notch and mouting hole for the sensors is actually cut into the MC
>block, not the tranny.
>If you have an MC or KH block, they should bolt right on...
>
>Peter Lines
Peter,
There is a notch in the tranny as well, but only on quattro models.
Otherwise one of the sensors doesn't have enough room and the notch has to
be made with a die grinder, not a hard job but I'd rather not do it :-)
Mihnea
More information about the quattro
mailing list