Turbo conversion question - crank sensors

[gerard]

> The notch and mouting hole for the sensors is actually cut into the MC
> block, not the tranny.
> If you have an MC or KH block, they should bolt right on...

Actually, the transmission casing (bell housing) does have some space to
accommodate the sensors. This is the case with my auto to manual tranny
conversion using an MC-1 engine and a 016 "UW" 5-speed transmission
which looks to be a very early 80s gearbox. I will have to cut some
metal from the transmission's front casing just to get the sensors in.
Not a major amount.

G.