relayed headlights

[james accordino]

You can run 4"-6" pieces to the mounting bolt for the
relay itself.  I used the same gauge wire and size
terminals as for the hot wires.  I think that's about
the shortest path?

Jim Accordino

--- no1of consequence <iin10ded at hotmail.com> wrote:
> you always want ground paths to be as short as
> possible and at least the
> same current capacity as the hot side wiring. the
> factory grounds probably
> run the current through all creation on its way back
> to the actual chassis.
>
> -jim
>
> <<<Is there any down side to grounding these back to
> the original headlight
> grounds in the factory harness?  It seems like only
> a minimal amount of
> current could be flowing though the triggers
> anyways...>>
>
>
>
>
_________________________________________________________________
> Tired of spam? Get advanced junk mail protection
> with MSN 8.
> http://join.msn.com/?page=features/junkmail
>


__________________________________________________
Do you Yahoo!?
The New Yahoo! Search - Faster. Easier. Bingo
http://search.yahoo.com