Flywheel pin information for KH motor
luke
maytagasm at sympatico.ca
Thu Aug 7 12:48:08 EDT 2003
my measurements were within 1/32.
it is definately about 1/8" thats about 0.125"
maybe you were right...
i really dont think it will make a difference though...
as long as the magnet can react to it.
i think the placement matters a fair bit...
but i dont think it needs precision...
as long as the magnet reacts to it
between teeth 35 and 36
luke
90tq
> I hate to throw a wrench into the works, but I seem to remember the MC
> timing pins being 4mm (.15748"). I am not sure it would matter, but it is
> what I used on my 80tq, with the (precision) measurements taken off of a
MC
> flywheel and documented here.
> These lightened 80 flywheels have been used on at least two 80 turbo
> conversions, so they work!
> http://www.newtsplace.com/90tq/index.php?content=faq.php&pagetitle=F.A.Q.
> #23
>
> > measured more... its 1/8" thick and its center point is
> almost exactly 3/4" down from the top of the teeth
> in a straight line...
> the 0 tdc mark is beside a tooth... next tooth over is 1
> the pin is between 35 and 36
>
>
More information about the quattro
mailing list