Crank bolt torque for timing belt change (10v)
Alan Pritchard
apritchard at seaeye.com
Mon Dec 1 11:21:06 EST 2003
HUH???
Torque is measured at the centre of the square drive, once its set to say
200 ft lb it doesn't matter if you turn it 10 cm from the square drive, or 2
miles. The only difference is the distance travelled at the handle
end........
-----Original Message-----
From: Michael G. Loeks [mailto:mloeks at columbia-center.org]
Sent: 01 December 2003 16:09
To: quattro at audifans.com
Subject: Re: Crank bolt torque for timing belt change (10v)
> Date: Mon, 01 Dec 2003 08:16:20 -0500
> From: Kneale Brownson <knotnook at traverse.com>
> Subject: Re: Crank bolt torque for timing belt change (10v)
> To: antar at comcast.net, quattro at audifans.com
> Message-ID: <4.1.20031201081221.017add20 at pop.traverse.net>
> Content-Type: text/plain; charset="us-ascii"
>
> I thought a torque wrench applied a measured amount of torque TO THE
> SQUARE
> DRIVE PART of its assembly????
>
> If you put a 258 ft. lb. torque setting on a torque wrench five feet
> long
> or one foot long and make it click, you've applied 258 ft. lb. of
> torque to
> the square drive fixture. The Audi tool is designed so that when you
> supply the desired torque to the hole in its end, you've applied the
> correct torque to the nut on the crankshaft.
>
I do not agree.
For practical purposes it doesn't make enough difference to specify the
length of the torque wrench. Any torque wrench that is capable of
delivering that amount of torque would have to be of a certain length to
be manageable. However, the torque would vary dramatically if a 1 ft
wrench were used vs. a 5 ft wrench. Think of it like this:
Assuming a 1ft long SST with 258ft-lb delivered at the end of the torque
wrench,
1ft torque wrench = 258lb on end X 2ft = 516ft-lb at bolt.
4ft torque wrench = 64.5lb on end X 5ft = 322ft-lb at bolt.
5ft torque wrench = 51.6lb on end X 6ft = 309.6ft-lb at bolt.
So the final torque is dependent on the length of the torque wrench since
the SST is a constant. The longer the torque wrench is, the less
significant the SST becomes. It would also appear that error could be
introduced depending on where the torque wrench were held.
I personally use the cheater pipe on the breaker bar method.
Mike
_______________________________________________
quattro mailing list
quattro at audifans.com
http://www.audifans.com/mailman/listinfo/quattro
More information about the quattro
mailing list