Propeller Shaft support bearing fix for 85 4KQ needed

[Denis]

  I did for u-joint.
  For the center bearing.... drill a 1mm hole on the seal fill with
hypodermic needle  then wash it with antigrease product then close the hole
with silicone.

  Denis

  noi grease = water come in = scrap bearing..... rebuilt driving shaft =
$$$$$ oo O o ooo

  ----- Original Message ----- 
  From: "Robert Myers" <robert at s-cars.org>
  To: "Per Lindgren" <lindgre at online.no>; <Stpndsmnn at aol.com>;
<Quattro at audifans.com>
  Sent: Wednesday, December 10, 2003 6:56 PM
  Subject: Re: Propeller Shaft support bearing fix for 85 4KQ needed


  >
  > I had mine ('95 S6) out a few weeks ago.  As far as I can tell, there is
no
  > way to grease the bearing.  There is definitely no zerk fitting.  I
managed
  > to force some grease in using a hypodermic needle grease tool.
Certainly
  > not ideal.  :-(
  >
  > At 12:49 AM 12/11/2003 +0100, Per Lindgren wrote:
  > >I want to ask this question, after getting the Bentley manual a few
weeks
  > >ago. It says in there that the axle bearing needs to be greased
regularly.
  > >How many of you can honestly say that you've done this? No, I havent
  > >greased it either!
  > >
  > >PerL
  > >87 Cq
  >
  > _____
  > "I never give them hell. I just tell the truth and they think it is
  > hell!"  Harry Truman
  >
  > Bob
  > *****
  >   Robert L. Myers 304-574-2372
  >   Rt. 4, Box 57, Fayetteville, WV 25840 USA WV tag Q SHIP
  >   '95 urS6 Cashmere Grey - der Wunderwagen  ICQ 22170244
  >   http://www.cob-net.org/church/pvcob.htm
  > *****
  >
  >


----------------------------------------------------------------------------
--


  > _______________________________________________
  > quattro mailing list
  > quattro at audifans.com
  > http://www.audifans.com/mailman/listinfo/quattro
  >