4kq propshaft u-joint part number?

[rizov_d at shaw.ca]

[ Converted text/html to text/plain ]

Not on my car!

I damaged 2 bolts and now I'm looking to heat up with a torch.

Any other ideas?



Dobby

----- Original Message -----

From: Mihnea Cotet <mik at info.fundp.ac.be>

Date: Tuesday, February 4, 2003 4:15 pm

Subject: Re: 4kq propshaft u-joint part number?

> Dobby,
>
>
> IME, not a single driveshaft/CV Joint bolt has ever resisted to a
> good
> impact wrench, most of them take about 2 seconds to loosen and
> remove with
> the proper equipment...
>
> HTH,
>
> Mihnea
>
> At 16:02 4/02/2003 -0700, rizov_d at shaw.ca wrote:
> >[ Converted text/html to text/plain ]
> >
> >
> >
> >Have you expirienced almost welded bolts at the CV flanges at
> drive shaft?
> >
> >(What is the way to deal with hard to open bolts at both ends of
> the propeller
> >shaft?)
> >
> >They are fixed with locktite or similar!
> >
> >
> >
> >Dobby
> >
> >86 4kq
> >
> >--- Original Message -----
> >
> >From: tihol_tiholov at sd27.bc.ca
> >
> >Date: Monday, February 3, 2003 12:10 pm
> >
> >Subject: Re: 4kq propshaft u-joint part number?
> >
> > >
> > > >Date: Sun, 2 Feb 2003 21:36:37 -0500
> > > > ... In my recent archive search for 4kq center support /bearing
> > > posts, I
> > > >came across a post that mentioned a FAG part number for the u-
> joint.> >
> > > No BTDT, just what I have from past posts, edited:
> > >
> > > "4000/80/90 Drive shaft carrier bearing BMW #26-12-1-209-532
> > > (includes bearing, bracket, rubber)
> > > Brendan Rudack <rudack at ucsub.Colorado.EDU>
> > > With the help of Steve B. Bruce B. and Graydon S. my 90Q is
> > > running again with about $50 dollars of parts. I rebuilt my center
> > > drive-shaft (carrier bearing and u-joint only). The bearing was
> > > gottenthrough GPR and is BMW part# 26121209532. It is the bearing
> > > including the
> > > rubber surround and the mounting bracket as one piece, total cost
> > > $35."
> > > Greetings,
> > > Tihol
> > >
> > >
> > >
>
>