[Fwd: Re: Re: Question to CQ ('90-'91) owners]

[auditude at cox.net]

ONCE AGAIN I've gotten unsubbed involuntarily for some reason!  My actual post is below this bounce message.

> From: quattro-admin at audifans.com
> Date: 2003/02/14 Fri PM 02:55:10 EST
> To: auditude at cox.net
> Subject: Your message to quattro awaits moderator approval
>
> Your mail to 'quattro' with the subject
>
>     Re: Re: Question to CQ ('90-'91) owners
>
> Is being held until the list moderator can review it for approval.
>
> The reason it is being held:
>
>     Post by non-member to a members-only list

> From: <auditude at cox.net>
> Date: 2003/02/14 Fri PM 02:47:11 EST
> To: "Dave K." <desmo888 at comcast.net>, quattro at audifans.com
> Subject: Re: Re: Question to CQ ('90-'91) owners
>
> I think there is a measurement (30mm) for the 256mm U.S. spec 90q20v rotor, but not the 276mm Euro spec G60 version.
>
> Thanks,
>
> Ken
>
> "Dave K." <desmo888 at comcast.net>
> >
> > I believe this info is on the 20v.org site.
> >
> > Dave K.
> > '90 CQ
> >
> > ----- Original Message -----
> > From: <auditude at cox.net>
> > To: <quattro at audifans.com>
> > Sent: Friday, February 14, 2003 11:02 AM
> > Subject: re: Question to CQ ('90-'91) owners
> >
> >
> > Yes, please measure that.  I would like that information as well.  I
> > understand the measuring method for that dimension is correct, from the
> > surface the wheel bolts to, to the surface of the friction face.
> >
> > I informally measured that dimension on my 90q20v 276mm rotors, for G60's,
> > and I thought it was around 27mm.
> >
> > Thanks,
> >
> > Ken
> >
> > Tony Lum tlum at flash.net
> >
> > Hi gang,
> >
> > Could one of the Coupe quattro owners about to do a front brake job or just
> > completing one take a measure of the hat size?  To my understanding, that's
> > the dimension from the rotor surface to the top of the hub surface.
>