E-bay 4kq: Good news, ugly discovery, one minor q...

[R Mangas]

Sounds reasonable, and I'm undoubtedly due, but why would pulling the
upright cause failure?  It was fine before.  Also, when I bounce the car in
the garage I can see no motion at the bearing but the strut shaft goes up
and down...  Still think it's just that?

  Thanks!

Robert




>From: JShadzi at aol.com
>To: porter_dog at hotmail.com, quattro at audifans.com
>Subject: Re: E-bay 4kq:  Good news, ugly discovery, one minor q...
>Date: Fri, 14 Feb 2003 09:29:43 EST
>
>You need a new strut bearing.
>Javad
>
>In a message dated 2/14/2003 6:00:14 AM Pacific Standard Time,
>porter_dog at hotmail.com writes:
>
> > Minor q- to swap the bearings out I pulled the uprights and used a
>press.
> > It went smoothly, but now I've got a bit of vertical freeplay at the
>strut
> > bushing on the pass side.  It acts like I just didn't get the main nut
>at
> > the top tight enough, but I used an impact gun.  Any insights?
>


_________________________________________________________________
STOP MORE SPAM with the new MSN 8 and get 2 months FREE*
http://join.msn.com/?page=features/junkmail