'86 5000TQ no start...

[John Forbes]

This is a multi-part message in MIME format.
--
[ Picked text/plain from multipart/alternative ]
Well today I didn't have as much time or help as in previous nights, but I =
did get a bunch more info. Finally got the car to go into diagnostic mode, =
found a loose wire. It reads out code 2113 which means its not recieving si=
gnal from the hall sender. So I went back and tested the hall sender for th=
e who-knows-how-many-ith time and it tested ok again. Then I figured I woul=
d test the signal at the ECU connector while cranking, but my multimeter di=
dn't react fast enough to get a clear reading. It did show over 4 volts, bu=
t I couldn't tell if it was dropping down to the proper 0-.5, only that it =
was indeed fluctuating. So where I'm at now is the ecu says its not getting=
 signal, but I know that it is. Any ideas?

-Cody
--