Fw: Control Pressure Actuator test harness parts?

[Huw Powell]

> > My 86 4kq is running a bit crappy and all my Audi mechanic did was lunge
> for
> > the 3mm hex screw and adjust at random, despite the fact that they say
> they
> > have a CO tester. I questioned them on that and they said that it isn't
> > accurate! As if a shot in the dark with the 3mm screw is... I was
> > non-plussed.
> >
> > So now I'm building the test harness as described on Huw's Site Of
> > Knowledge.
> > Fuse: check
> > Test connector: check
> > Male CPA connector: check
> >
> > Where, though, do I scavenge the female connector to replicate the
> connector
> > on the CPA? My parts source is an 86 4kq.

They are rarer than the other half - there is really only one source,
and that is the heater portion of the harness that comes with the 3 wire
oxygen sensor.

--
Huw Powell

http://www.humanspeakers.com/

http://www.humanthoughts.org/