Cheep 3034? or???

[Todd Phenneger]

I missed the start of the thread.  If you guys are talking about
the Pilot Bearing, I just stuck the head of my grease gun in
there and pumped it a few times.  The grease had no where to go
but to force the bushing out.  Easy and worked really well.
  YMMV...suppose it depends on the size of your grease gun
nipple. :-)
l8r
  Todd

--- Gerard <gerard at poboxes.com> wrote:
> I used the same idea I had used to remove the bushing on the
> crank of
> auto transmissioned MC engine. Get a longish bolt with the
> proper
> thread, put it through a handle of a tap set, screw the bolt
> into the
> pulley centre hole, then use the handle as a slidding hammer
> knocking
> against the bottom of the bolt head.
>
> G.


__________________________________
Do you Yahoo!?
SBC Yahoo! DSL - Now only $29.95 per month!
http://sbc.yahoo.com