Cheep 3034? or???

Gerard gerard at poboxes.com
Fri Jun 27 12:02:22 EDT 2003


I tried using a fat bolt to do this. I was advised to pack grease into
the bushing and behind it and use the tight fitting bolt to pressure the
grease. I wound up with grease all over me. :P

I suppose a tight fitting grease gun would have worked well, but my
grease gun didn't like me on the day.

Todd Phenneger wrote:
>
> I missed the start of the thread.  If you guys are talking about
> the Pilot Bearing, I just stuck the head of my grease gun in
> there and pumped it a few times.  The grease had no where to go
> but to force the bushing out.  Easy and worked really well.
>   YMMV...suppose it depends on the size of your grease gun
> nipple. :-)
> l8r
>   Todd
>
> --- Gerard <gerard at poboxes.com> wrote:
> > I used the same idea I had used to remove the bushing on the
> > crank of
> > auto transmissioned MC engine. Get a longish bolt with the
> > proper
> > thread, put it through a handle of a tap set, screw the bolt
> > into the
> > pulley centre hole, then use the handle as a slidding hammer
> > knocking
> > against the bottom of the bolt head.
> >
> > G.
>
> __________________________________
> Do you Yahoo!?
> SBC Yahoo! DSL - Now only $29.95 per month!
> http://sbc.yahoo.com



More information about the quattro mailing list