Cheep 3034? or???

[Todd Phenneger]

Yea,
  I didn't believe it when I heard it.  But it worked for me for
some reason.
  l8r
       Todd

--- Gerard <gerard at poboxes.com> wrote:
> I tried using a fat bolt to do this. I was advised to pack
> grease into
> the bushing and behind it and use the tight fitting bolt to
> pressure the
> grease. I wound up with grease all over me. :P
>
> I suppose a tight fitting grease gun would have worked well,
> but my
> grease gun didn't like me on the day.
>
> Todd Phenneger wrote:
> >
> > I missed the start of the thread.  If you guys are talking
> about
> > the Pilot Bearing, I just stuck the head of my grease gun in
> > there and pumped it a few times.  The grease had no where to
> go
> > but to force the bushing out.  Easy and worked really well.
> >   YMMV...suppose it depends on the size of your grease gun
> > nipple. :-)
> > l8r
> >   Todd
> >
> > --- Gerard <gerard at poboxes.com> wrote:
> > > I used the same idea I had used to remove the bushing on
> the
> > > crank of
> > > auto transmissioned MC engine. Get a longish bolt with the
> > > proper
> > > thread, put it through a handle of a tap set, screw the
> bolt
> > > into the
> > > pulley centre hole, then use the handle as a slidding
> hammer
> > > knocking
> > > against the bottom of the bolt head.
> > >
> > > G.
> >
> > __________________________________
> > Do you Yahoo!?
> > SBC Yahoo! DSL - Now only $29.95 per month!
> > http://sbc.yahoo.com


__________________________________
Do you Yahoo!?
SBC Yahoo! DSL - Now only $29.95 per month!
http://sbc.yahoo.com