Dist Cap/Rotor - No Start
Bhatti, Mohammed
Mohammed.Bhatti at si-intl.com
Sun Mar 16 11:39:36 EST 2003
Folks,
Decided to replace the cap and rotor yesterday on my 88 80q. Took the old
cap off. Took the rotor off and replaced with new. Plugged in wires from
the old cap one by one and (I think) in the same order. Now, when I try to
start the engine turns but wont start.
So have I mixed up the wires? I even put the old cap/rotor back to no
avail. Also lined up the rotor to point to the hall sender on the cap again
to no avail. BTW, is #1 cylinder where the hall sender is or is it two
poistions down on the dist cap?
Any ideas or what I should look for next?
Thanks
mohammed
88 80q
More information about the quattro
mailing list