Dist Cap/Rotor - No Start

[InfernoCL]

You probably mixed the wires

-----Original Message-----
From: quattro-admin at audifans.com [mailto:quattro-admin at audifans.com] On
Behalf Of Bhatti, Mohammed
Sent: Sunday, March 16, 2003 10:40 AM
To: 'quattro at audifans.com'
Subject: Dist Cap/Rotor - No Start

Folks,

Decided to replace the cap and rotor yesterday on my 88 80q.  Took the old
cap off.  Took the rotor off and replaced with new.  Plugged in wires from
the old cap one by one and (I think) in the same order.  Now, when I try to
start the engine turns but wont start.

So have I mixed up the wires?  I even put the old cap/rotor back to no
avail.  Also lined up the rotor to point to the hall sender on the cap again
to no avail.  BTW, is #1 cylinder where the hall sender is or is it two
poistions down on the dist cap?

Any ideas or what I should look for next?

Thanks

mohammed
88 80q