Eurospec's stroker kit pricing

[Marc Swanson]

> Would those pistons above, or pistons like them, be all that is needed to run 8.5:1
> compression ratio with an MC-1 block, crank, and rods, and a 7A head?

I can't answer any of the other questions in your email (Javad?), but I
can let you know my experience with buying pistons from JE.

> Shouldn't those pistons cost closer to $700, or even $800?  I couldn't find it just now, but I
> thought Marc Swanson had some info on his site on how much his stuff cost him.


yes, the pistons were not that bad.  They were custom made to my specs
for under $800 for the set.  In fact I think the pistons, wrist pins,
and total seal rings came to under $1000 for everything.

I don't have the invoice to get exact numbers for you but I was able to
dig up the spec sheet for the pistons I had made:

http://www.mswanson.com/phpix/?mode=view&album=Audi%2Fold_photos&pic=je.jpg&dispsize=640&start=80


Good luck with the stroker crank project.  I always thought the Eurospec
package sounded like a good deal as well.


Later

--
----------------------------------
Marc Swanson, Software Engineer
Sonitrol Communications Corp.
Hartford, CT

Email: mswanson at sonitrol.net
Phone: (860) 616-7036
Pager: (860) 948-6713
 Cell: (603) 512-1267
  Fax: (860) 616-7589
----------------------------------