Front end still rattles when going over bumps....

Robert Mangas porter_t_dog at hotmail.com
Fri Nov 21 22:51:22 EST 2003


  A-arm bushings can easily do that, as can a bad tie rod end or sway bar 
bushings.

>From: David Thoresen <david at epicfoto.com>
>To: <quattro at audifans.com>
>Subject: Front end still rattles when going over bumps....
>Date: Fri, 21 Nov 2003 19:29:29 -0800
>
>Thanks for everyone help with this project... I finally got the CV joint
>off... Quite easy when I get some instructions!
>
>Well I have now replaced the ball joints, shocks, upper strut mounts, and
>when going over a bump there is still a slight rattle from up front... what
>the heck is that from??  I am getting an alignment done tomorrow, but if I
>need to replace something else under there I might delay that till it is
>fixed.  **grunt**
>
>Should I look at the control arm bushings as a possibility?
>
>Thanks!
>David
>'90 90q 20v
>
>_______________________________________________
>quattro mailing list
>quattro at audifans.com
>http://www.audifans.com/mailman/listinfo/quattro

_________________________________________________________________
Say “goodbye” to busy signals and slow downloads with a high-speed Internet 
connection! Prices start at less than $1 a day average.  
https://broadband.msn.com (Prices may vary by service area.)



More information about the quattro mailing list