Type-44: pressing hub into front wheel bearing

Livolsi, Stephane Stephane.Livolsi at investorsgroup.com
Wed Nov 26 00:55:21 EST 2003


Hi Ameer.  I just did a rear one on my type 44 and I think it is similar
to the fronts.  There should be a snap ring in a groove in the hub.  The
bearing gets pressed in until it's snug up against the snap ring, then
the second snap ring can be put in.  Like I said, this was on the rear,
but I am quite certain the front is the same.

Stephane

> -----Original Message-----
> From: Ameer Antar [mailto:antar at comcast.net] 
> Sent: November 25, 2003 7:08 PM
> To: Quattro List
> Subject: Type-44: pressing hub into front wheel bearing
> 
> 
> Can someone tell me how far to press the wheel hub into the 
> front wheel bearing? I assume it should go in until the edge 
> of the inner part of the hub is flush w/ the inner race of 
> the bearing, but want to be sure. Or should I have it pressed 
> in a little bit less than that position and use the 
> driveshaft nut to press the hub in the rest of the way? TIA.
> 
> -Ameer
> _______________________________________________
> quattro mailing list
> quattro at audifans.com http://www.audifans.com/mailman/listinfo/quattro
> 



More information about the quattro mailing list